Repeater Mode

As a repeater RoboDot will receive corrections over LoRa and make those available over the local NTRIP caster thereby extending correction range up to 1km between base and rovers.

Entering Repeater Mode

  1. Enable Lora radio in settings

  2. Select repeater as boot mode

  3. Restart device

  4. Device maintains repeater function until boot setting changes

Requirements:

  • Two RoboDots minimum

  • Both need LoRa radio capability on the same channel

  • One requires repeater functionality

Deploying

  1. Maintain single base reference with lora enabled

  2. Connect a rover to a repeater's NTRIP

Was this helpful?